Why Use a 6-Inch 25mm Body Tube?
The Quest Q-jet Body Tube 6" 25mm (Black) - Q11314 is a replacement component designed for model rocketry. With a 6-inch length and a 0.944-inch inner diameter (25mm), it fits standard 25mm motor mounts and tube couplers. Its kraft paper construction with a black outer wrap gives your rocket a clean, finished look without extra painting or covering.
This tube is compatible with Quest Q-jet model rocket kits and parts, making it a straightforward choice for repairs, custom builds, or extending an existing airframe.
Body Tube Specifications
- Body Tube 6" 25mm (Black) - Q11314: The tube measures 6 inches in length with a 0.944-inch inner diameter, a 0.984-inch outer diameter, and a 0.020-inch wall thickness. These dimensions confirm the tube fits standard 25mm (BT-50 size) components, including motor mounts, couplers, and nose cones.

Body Tube 6" 25mm (Black) - Q11314 - Body Tube 6" 25mm (Black) - Q11314: The tube features a kraft paper construction with a black outer wrap. The black outer wrap eliminates the need for painting if you want a dark airframe, and kraft paper provides good strength for lightweight builds.
- Body Tube 6" 25mm (Black) - Q11314: Compatible with Quest Q-jet model rocket kits and parts. You can use this tube as a direct replacement or as a building block in any Quest Q-jet design, ensuring proper fit with other Quest components.
How to Install the 6-Inch Body Tube
Follow these steps to incorporate the 6-inch 25mm body tube into your rocket build.
- Measure and Mark: Use a ruler and a fine-tip marker to mark the desired cut point on the tube. If you need a shorter section, measure from one end; the tube's 6-inch length gives you room to cut to size.
- Cut the Tube: Wrap a piece of masking tape around the tube at the mark to guide a straight cut. Use a hobby knife or a fine-tooth saw, rotating the tube as you cut. Sand the cut edge lightly with fine-grit sandpaper to remove burrs.
- Dry Fit Components: Slide the tube onto your motor mount or coupler to check fit. The 0.944-inch inner diameter should slide smoothly over a 25mm tube coupler. If it is tight, sand the inside edge slightly; if loose, a thin layer of glue will fill the gap.
- Glue and Assemble: Apply a thin bead of wood glue or epoxy to the joint surfaces. Insert the tube and twist it slightly to spread the adhesive. Wipe away excess glue with a damp cloth. Allow the glue to cure fully before handling.
- Finish the Surface: The black outer wrap is already finished. If you cut the tube, the raw edge may show kraft paper; touch it up with a black marker or a thin coat of paint. For a glossy look, you can apply a clear coat over the entire tube.
Tips for a Clean Build
The 0.020-inch wall thickness provides good structural integrity for a lightweight rocket. Avoid over-sanding the tube, which can weaken the wall. If you are joining two tube sections, use a tube coupler that matches the 0.944-inch inner diameter for a snug fit.
Because the tube is made of kraft paper, it is moisture-sensitive. Store your rocket in a dry place and avoid launching in wet conditions. The black wrap is cosmetic only; it does not add water resistance.


