AeroTech N2000W-PS RMS-98/15360 Reload Kit Prep Guide

By Quest Q-jet | Published: 2026-11-03

Category: Guide pratiche

Prep the AeroTech N2000W-PS RMS-98/15360 reload kit correctly. Follow the assembly steps, install the 98FSD forward seal disc, and avoid common mistakes.

Quick answer

Assemble the N2000W-PS reload kit only after you have the correct RMS-98/15360 motor hardware and the 98FSD forward seal disc. Work through the steps below in order, checking each component before you proceed.

Why the 98FSD forward seal disc is not optional

This reload kit requires installing a forward seal disc (98FSD) during assembly. That disc is not a generic extra—it is a specified part for this motor. Skipping it or substituting another disc can prevent the motor from sealing correctly. Confirm you have the 98FSD on hand before you start, because the kit alone will not complete the motor.

Hardware is separate: plan before you build

The RMS-98/15360 motor hardware is sold separately, either as a complete set or as individual parts. The reload kit is assembled by the user into that reusable aluminum case. If you are missing a hardware component, you cannot finish the motor, so inventory your case, closures, and seal disc first. This is also a good time to inspect the case and closures for damage.

Large-motor prep is a check, not a race

With a 98mm motor, a single missed step is harder to catch later. Build in checkpoints: verify parts, verify orientation, verify torque. The steps below give you those checkpoints, but they assume you are following the manufacturer’s instructions for the N2000W-PS. Where this guide and the manufacturer’s instructions differ, follow the manufacturer.

N2000W-PS assembly steps

Inventory the kit and hardware: Lay out all reload kit components, the RMS-98/15360 motor hardware, and the 98FSD forward seal disc. Compare against the parts list. Missing the 98FSD? Stop and source it before proceeding.
Inspect the case and closures: Check the aluminum case, forward closure, and aft closure for damage, debris, or wear. Clean any residue. Do not assemble if you find cracks or damaged threads.
Install the forward seal disc (98FSD): Place the 98FSD in the forward closure as specified in the instructions. Confirm it sits flat and fully seated. A cocked seal disc is a common cause of leaks—recheck seating.
Assemble the reload into the case: Follow the manufacturer’s sequence for installing grains, O-rings, and the aft closure. Lubricate O-rings only as directed. Do not force any component; if it binds, stop and recheck orientation.
Final torque and function check: Torque closures to the manufacturer’s specification. Verify the assembly is fully seated and the delay element is installed if applicable. Record the assembly date and delay setting for your flight log.

Product facts

AeroTech N2000W-PS RMS-98/15360 Reload Kit (1 Pack) - 14200P: The AeroTech N2000W-PS RMS-98/15360 Reload Kit (1 Pack) - 14200P is a reload kit that requires AeroTech RMS-98/15360 motor hardware and a 98FSD forward seal disc. You cannot complete this motor with the kit alone, so confirm both the hardware and the 98FSD before assembly.
AeroTech N2000W-PS RMS-98/15360 Reload Kit (1 Pack) - 14200P