AeroTech 1.9 Inch Launch Rails: Quick Setup Guide

Quick Answer

Install AeroTech 1.9 inch launch rails by securing them to your launch pad with the included hardware, ensuring they are parallel and level. Use them to guide your rocket during liftoff for stable, straight flight.

5-Step Setup and Use Guide

1. Step 1: Gather Tools and Inspect Rails: Unpack the two AeroTech 1.9 inch Launch Rails. Check for any bends or damage. You'll need a ruler, a level, a drill (if your launch pad doesn't have pre-drilled holes), and the mounting hardware (screws and nuts, not included with the rails). A bent rail will cause flight issues; replace it before proceeding.
2. Step 2: Position Rails on the Launch Pad: Place the two rails parallel to each other on your launch pad, spaced exactly 1.9 inches apart (center to center). Use a ruler to verify the gap is consistent along the entire length. Mark the mounting hole locations on the pad. Inconsistent spacing can bind the rocket's launch lugs, causing a hang-up or tilt.
3. Step 3: Secure the Rails: Drill pilot holes if needed, then attach each rail using screws and nuts. Tighten them firmly, but avoid over-tightening which could warp the rail. Use a level to confirm both rails are perfectly vertical (plumb) and parallel to each other. A non-level rail will launch the rocket at an angle, affecting trajectory.
4. Step 4: Test Fit Your Rocket: Slide your rocket's launch lugs onto the rails. The rocket should move smoothly with minimal friction. If it sticks, check for debris or misalignment. Adjust the rail spacing slightly if necessary. A tight fit can prevent the rocket from clearing the rail; a loose fit can cause wobble.
5. Step 5: Launch and Observe: Connect your igniter and launch controller. After ignition, watch the rocket's travel along the rails. A smooth, straight ascent indicates correct setup. If the rocket tilts or wobbles, re-check alignment and rail spacing before your next launch. The first launch is a real-world test; use it to fine-tune your installation.

Product Fact

• AeroTech 1.9 inch Launch Rails (White) - 19039P: Sold as a pair, these white launch rails help ensure stable and straight flight by properly aligning your rocket during liftoff. Having two rails allows you to create a precise guide channel, minimizing lateral movement and keeping the rocket on a true vertical path.